Hi All
K-mac have only made one prototype set and I've had them in my Monza for a long time - they needed a section of chassis, trailing arm, cover plate and bolt damper and bush to make a proper one. I cut this out of a car in preparation (a year or two ago) but I needed to send to Australia so he can take proper measurements and make a production mold to produce a bush to the same design as the prototype. This happened this summer.
My original prototype one was made using a mold made from a bush I sent him so in terms of finish and design it can only be described as rough and ready but functional.
Because it was made from a mold made from a bush it has the void areas - the final version will be totally round so orientation when fitting will not be an issue - it will also be voided probably 4-6 holes and made from same grade of Poly that the other donut bushes were made from.
I'm not interested in getting OZ grade stuff for UK use we've seen it happen before they are obsessed with stiffness and lack of any compliance (I believe the aussies associate lack of compliance and stiffness with great handling........ )
So I have a group buy running on the ABS and I'm throwing it open to you too (logistics however will be slightly different (as will cost - hopefully you won't have the same duty issues (6% import tax on cost of item and shipping with then 20% on top of it all again) and I'm sure I don't need to ship them to the UK to then send back to NZ
(Hoping someone will help here and act as a co-ordinator)