left lwer arm,drive shaft,strut wanted for astra,vectra,cali

[175 Sudheer R]

Hey guys had a mis-happ with the astra.Any one has the following: l/f lower arm,left drive shaft,left strut.also do vectra A's have solid rear beam axel or independant.Thanks

[020 Brad]

Vectra A's have both torsion beam and IRS, but I think the beam may possibly be wider than the Astra, so be careful here.

I might be able to help with some standard struts or something, but I think the lower arms are different, possibly the balljoints too?

[175 Sudheer R]

cool,basically my running gear is a full 20xe setup so standard gt2000 arm,drive shafts and strut will do.do you have any rear solid axel?

[127 Gordo]

You can pick up wishbones for around $40 from the UK, but last time I checked it's cost another $160 or so for freight, etc.
What year was yours, PickaPart often have them in stock - you may be able to use your strut insert for it - http://www.pickapart.co.nz/stock.asp

[020 Brad]

cool,basically my running gear is a full 20xe setup so standard gt2000 arm,drive shafts and strut will do.do you have any rear solid axel?

No sorry, only a spare IRS setup but as Gordo mentions above, the run of the mill 8v Vectras used the beam rear and I don't think I've been to pick-a-part without at least one of those sitting there.

[196 Aled J]

vectra A rear beam should fit the astra, i fitted a vectra A disc beam to my mk 2 astra or kadett g (i think they were called here??) a few yrs ago and have the same beam sitting in the workshop ready to go on my astra f.
may have an astra f drum beams going spare but im guessing you'd prefer the disc option??

[175 Sudheer R]

Thanks,my car is now back on the road,however i do need to set it up on a chassis machine to pull the rear subframe across by 15mm.Got to admit its not bad damage after putting the car sideways into a curb at 145km........Damaged parts were x3 broken wheels,bent rear axle,bent front lower arm,bent front hub,crushed cv,bent rear disc and x1 broken side skirt.No damage to body apart from rear axle hangers.All the above happened on the day that the car actually ran well after new exhaust system and a wee tune.I want to get it on a dyno.My guess is that it is around 200-230 kw because of loss of traction in 3rd gear in dry conditions.

[127 Gordo]

You're bonkers, Sid
However, I trust that was on a closed road/racetrack under supervision...

Re a dyno day, Eurosport are talking about having one sometime - but it may be a few weeks/months (years? ) away. They're usually $80-100 for two pulls.

[175 Sudheer R]

Yes it was on a closed road. 80-100 isnt bad at all